Article ID: 1020, created on Oct 6, 2008, last review on May 8, 2015

  • Applies to:
  • Virtuozzo


  1. First of all, you should request a Virtuozzo VPN certificate using the following web form:

  2. After the certificate is received the following steps should be done for configuring VZVPN:

    # key-install license.vzvpn

    (replace license.vzvpn with the actual filename) will install your certificate;

  3. Start VPN:

    # start

    This command will set up network interface tap0 which will be used by the support team to connect to your server.

  4. When the job is done, use command below to close the tunnel:

    # stop

    Note: OpenVPN uses port 80 for communication, so, please, make sure this port is open and configure proxy in /etc/vzvpn/vzvpn.conf if needed. You can also use port 443. It can be configured in the same configuration file.

0dd5b9380c7d4884d77587f3eb0fa8ef 2897d76d56d2010f4e3a28f864d69223

Email subscription for changes to this article
Save as PDF