Article ID: 115363, created on Dec 28, 2012, last review on May 8, 2014

  • Applies to:
  • Virtuozzo containers for Linux 4.7
  • Virtuozzo containers for Linux 4.6
  • Virtuozzo hypervisor 5.0
  • Virtual Automation 4.6


While installing PVA Agent on a Hardware Node, the operation fails on Power Panel component installation. The following error is observed:
Cannot make an IPv6 address for SVE. Don't start it


Most likely, there is no default gateway on the Hardware Node, which is why the Power Panel installation script fails.


Make sure the below commands show valid default gateway settings and the correct Hardware Node to be used as the default interface:
# ip route list | awk '$1 == "default" { for(i=2;i<NF;++i) { if($i == "dev") { print $(i + 1); exit } } }'

# ip route list | grep default

If the output is empty, then configure the correct default gateway settings on the server.

36627b12981f68a16405a79233409a5e 2897d76d56d2010f4e3a28f864d69223 d02f9caf3e11b191a38179103495106f e8e50b42231236b82df27684e7ec0beb d16a8794b3bdb3f66571d469e71906a9 319940068c5fa20655215d590b7be29b 0c05f0c76fec3dd785e9feafce1099a9 c662da62f00df94fd77ba7a2c9eff4b4 a26b38f94253cdfbf1028d72cf3a498b

Email subscription for changes to this article
Save as PDF